Vulcan-Hart ML-135503 Especificaciones descargar pdf (Pagina 6)

– 6 –

Fig. 1

Attach the restraining device at the rear of the fryer (Fig.1).

If disconnection of the restraint is necessary, turn off the gas supply before disconnection. Reconnect

this restraint prior to turning the gas supply on and returning the fryer to its installation position.

GHF SERIES FRYERS - BATTERY TYPE (HEAVY DUTY STYLE)

Set all fryers in line with each other and adjacent ranges (16" [40 cm] clearance required between fryer

and open top flame units). Remove control panels for access to union connections or manifold pipes.

Screw each union finger-tight to adjoining connection. Do not overtighten. Tighten each union in turn,

ensuring that the gas manifold is not pulled to the left or right by overtightening the unions. When all

fryers in the battery are connected finger-tight, then tighten with a pipe wrench. Always use pipe joint

compound that is resistant to the action of liquid petroleum gases on unions.

GAS CONNECTIONS

CAUTION: All gas supply connections and any pipe joint compound used must be resistant to

the action of propane gases.

All fryers are equipped with fixed orifices for use with either natural or propane gas, as ordered, and

no adjustment is necessary.

Fryers for operation on natural or propane gas must have a pressure regulator with an outlet pressure

of 4.0" Water Column for natural gas supply, and 10.0" Water Column for propane gas supply. These

pressure regulators are available from Vulcan-Hart.

Codes require that a gas shutoff valve be installed in the gas line ahead of the fryer.

Connect gas supply to the fryer. The gas supply line must be at least the equivalent of

/4" (19 mm) iron

pipe. Make sure the pipes are clean and free of obstructions, dirt, and piping compound.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Vulcan-Hart ML-135503 Especificaciones Pagina 6