Vulcan-Hart ERD50F 126906 Manual de instrucciones

VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201-0696, TEL. (502) 778-2791OPERATION MANUALFor additional information on Vulcan-Hart Company or

– 10 –MAINTENANCEWARNING: HOT FRYING COMPOUND AND PARTS CAN CAUSE BURNS. USE CARE WHENOPERATING, CLEANING OR SERVICING THE FRYER. USE CARE WHEN FILTER

– 11 –FRYER BOIL-OUT INSTRUCTIONSCAUTION: Do not run water or boil-out solution through the filter motor or pump. Do not usethe filter during boil-o

– 12 –FORM 31234 Rev. A (Apr. 2003) PRINTED IN U.S.A.18. After rinsing the tank, close the drain valve and refill the tank with hot water to the - Max

– 2 –Table of ContentsGENERAL ...

– 3 –OPERATION AND CARE OFKLEENSCREEN FILTRATION SYSTEMSAVE THESE INSTRUCTIONSGENERALThe KleenScreen Filtration System filters the oil as it is pumped

– 4 –CONTROLS AND COMPONENT LOCATIONS — Gas FryersThe filter tank cover is removed to show component locations.Fig. 1

– 5 –CONTROLS AND COMPONENT LOCATIONS — Electric FryersThe filter tank cover is removed to show component locations.Fig. 2

– 6 –Fig. 3Fig. 4 Fig. 55. Turn the filter power switch ON (Fig. 6). The red pilot light in the filter power switch comes on.PL-41601PL-41602PL-41603

– 7 –6. To start filtering, pull out the red filter valve handle (Fig. 7) of the fryer tank to be filtered. Usea brush to remove all the residue from

– 8 –PL-416122. Set the fryer thermostat at 350°F (177°C).3. Once shortening has melted, stir oil to eliminatesolid shortening in the cold zone (Fig.

– 9 –PL-41615PL-416163. While holding the discard hose at the base of the fitting, use your free hand to slide the collaraway from the end of the fema