Vulcan-Hart ERD50F 126906 Manual de instrucciones descargar pdf (Pagina 7)

– 7 –

6. To start filtering, pull out the red filter valve handle (Fig. 7) of the fryer tank to be filtered. Use

a brush to remove all the residue from the bottom of the tank into the drain tube. Let the oil recycle

for 1 to 3 minutes, flushing residue from the tank bottom into the filter.

Fig. 8

PL-41605

PL-41606

Gas Fryer Electric Fryer

Fig. 9

9. Turn the filter power switch OFF (Fig. 6).

10. Close the fryer doors.

FILTERING PROCEDURE WHEN USING SOLID SHORTENING

1. Follow the fat melt procedure discussed in the INSTRUCTION manual supplied with your fryer.

WARNING: Do not set a complete block of solid shortening on top of an electric fryer's heating

elements. Doing this may damage the elements and increase the potential for shortening flash

fire. If solid shortening is to be used in an electric fryer, remove the baskets and crumb

screen(s), pack the bottom of the tank completely with solid shortening, lower the elements and

then pack the shortening COMPLETELY around over top of the elements. Lay crumb screen(s)

in the tank on top of the packed shortening. Follow the Fat Melt instructions in the ER Fryer

installation & operation manual. Once all shortening has been melted and the fryer has met the

set temperature, fill baskets and resume frying.

PL-41608

PL-41609

Gas Fryer Electric Fryer

Fig. 7

7. Close the red fryer tank drain lever (Fig. 8) by turning the

lever clockwise until it stops. The fryer tank will now

refill.

8. After filtering is complete (all oil is removed from the filter

tank and air bubbles should appear in the fryer tank),

push in the red filter valve handle completely (Fig. 9).

PL-41607

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Vulcan-Hart ERD50F 126906 Manual de instrucciones Pagina 7