Vulcan-Hart 7595 Manual de usuario descargar pdf (Pagina 6)

GAS SUPPLY CONNECTION

For proper installation of the 7400 and 7500 Series

Fryers, gas inlet pressure of at least 7.0"W.C. (Water

Column) for natural gas and 11.0"W.C. for propane gas

must be maintained while the unit is in operation. When

connecting unit gas supply, installation personnel must

install this equipment in accordance with all state and

local codes having jurisdiction. In the absence of local

codes, the National Fuel Gas Code ANSI Z223.1 (latest

edition) will apply.

NOTE:

1. The fryer and its individual shut off valve must be dis-

connected from the gas supply piping system during

any pressure testing of that system at test pressures in

excess of 1/2 psig (3.45 kPa).

2. The fryer must be isolated from the gas supply piping

system by closing its individual manual shut off valve

during any pressure testing of the gas supply piping

system at test pressures equal to or less than 1/2 psig

(3.45 kPa).

Each burner is controlled by a combination gas valve

pressure regulator. All 4 burner units are set for 5.5"W.C.

for natural gas and all 5 burner units are set for 5.3"W.C.

for natural gas. Both the 4 and 5 burner units are set for

10.0"W.C. for propane gas.

All gas supply connections any pipe joint compound used

must be resistant to the action of propane gases. Pipe

joints should be tested for leaks with a soap and water

solution before operation of unit.

UNITS MOUNTED ON CASTERS

Units mounted on casters utilizing a flex hose and quick

disconnect must be installed with a restraining device.

The restraining device must be connected at all times. If

disconnection of the device is necessary, reconnect the

restraint, after the unit has been returned to its original

installation position and before beginning unit operation.

In addition the quick disconnect device must comply with

the ANSI Z21.41 (latest edition) and ADDENDA, Z21.41 a

and Z21.41 b (latest editions) Standard for Quick Discon-

necting Devices used with Gas Fuel.

NOTE: All units on casters must be installed with a gas

connector that complies with the American National Stan-

dards ANSI Z21.69 (latest edition) and ADDENDA

Z21.69a (latest edition) for movable gas appliances.

ALL CASTER UNITS MUST BE INSTALLED PROVIDING

ADEQUATE MEANS TO LIMIT THE MOVEMENT OF THE

APPLIANCE WITHOUT DEPENDING ON THE CONNECTOR

AND ANY QUICK DISCONNECT DEVICE OR ITS

ASSOCIATED PIPING.

Installation of Unit Casters:

All 7400 and 7500 Series Fryers are shipped with casters

unmounted. Mounting casters to the unit will require (2) people.

After removing the fryer from the crate bottom carefully tilt fryer

to one side and install (2) casters front to rear utilizing (4) ea. of

the mounting bolts and hardware supplied. Repeat for other

side of fryer.

114590

1 2 3 4 5 6 7 8 9 10 11 ... 26 27

Comentarios a estos manuales

Sin comentarios

Vulcan-Hart 7595 Manual de usuario Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Freidoras Vulcan-Hart 7595