Vulcan-hart SG4D Manual de usuario descargar pdf (Pagina 18)

– 18 –

Lamp Assembly

1. Remove the lens and bulb.

2. Remove the springs from the retaining tabs

(two places) on the socket.

3. Depress the retaining tabs and pull the socket

out from the oven, far enough to disconnect

the lead wires.

4. Remove the socket from the oven.

RETAINING TABS

SPRING

CROSS SECTIONAL VIEW

PL-56055

3. Disconnect the lead wires from the high limit

thermostat. Remove the high limit thermostat

from the cover mounting plate.

4. Remove the old RTV silicone from the cover

and mating surfaces inside the oven cavity,

and apply new RTV silicone before installing.

5. Reverse procedure to install.

INTERIOR LIGHTS

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

1. Remove the racks from the oven.

2. Unscrew the glass lens for the light being

replaced, then unscrew the bulb.

3. Replace bulb, then reverse the procedure to

install.

LENS

OVEN CAVITY

PL-56054

HIGH LIMIT THERMOSTAT

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

1. Remove the top four racks from the oven.

2. Remove the high limit thermostat cover/

mounting plate. It is located at the top of the

oven cavity.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Sin comentarios

Vulcan-hart SG4D Manual de usuario Pagina 18